Perhaps someday he will start your printer appears on the screen of your Brother printer error 46, the error in a Brother printer is usually a bit costly if our decision is to contact support brother, mostly when this error happens is because Immediately printer is out of warranty has since reached the maximum impressions under the contract of guarantee.
And its lifetime is considerably older and not considered free repair by the support because he has given the necessities of life that comes from the factory use.
Cause of error 46 brother printers:
When the brother printers show this error on the main screen of your printer is because the ink absorption pad is full.
In English "Ink adsorbing pad". The support of the brother says it has to be replaced and you need to contact a technician of this team, it is difficult for users to get support from Latin America and the cost is in dollars or local weight value or local currency.
Then touches us is ourselves fix the error 46 when presented in Brother printers, and so we have created a content containing the solution to this problem.
Ads
By the presence and lack of presence of some buttons on some other printers this post only applies to these types of Brother Printers those shown below:
DCP-130C, DCP-135C, DCP-150C, DCP-330C, DCP-350C, DCP-540CN, DCP-560CN, DCP-750CW, DCP-770CW, MFC-235C, MFC-240C, MFC-260C, MFC 440CN, MFC-465CN, MFC-5460CN, MFC-5860CN, MFC-660CN, MFC-680CN, MFC-845CW, MFC-885CW
"The solution may appear to some other type of printer, it is possible in case additional information is needed on this case it is recommended to prepare a comment on this post, we will gladly answer the question."
Procedure to clear the error 46 in Brother Printers:
Know that with this we will return to the Brother printer accountant, this can cause a difference in the configuration of the printer, so the driver can appear on the computer connected to another port.
The printer driver after driver panel may have the letters "COPY 1", identifying that there is another printer. This is what was before.
Step # 1
The printer must be on to perform this configuration, preferably connected to the computer. The computer has this burning equally and fully operational.
Step # 2
Press "MENU / SET", "MONO / STAR" and "MENU / SET" again, waited 5 seconds.
Step # 3
"MAINTENANCE 10" is what will be shown on the screen below, and the two buttons to "FAX and COPY" will turn green.
Step 4
Precione ahacia button to navigate up and selecione the "MAINTENANCE 80" and press the "MONO / STAR" button followed by "MENU / SET" again.
Step # 5
Now go to where it says "PURGE" this option will find a value, it does not really matter the value we find.
Step No. 6
And in the purge now introduce the following code: 2783 "a beep will sound and the meter will · 0 ·".
Step # 7
Press "STOP / EXIT" to confirm.
Step No. 8
Disconnect the power of the printer and wait about 5 seconds,
"If the problems continue to develop a comment in this post we will gladly assist you."